Sphenoid Bone Determines the Curvature of the Cranial Vault in Postnatal Skull Development in C57BL/6 Mice
Article information
Abstract
Background
The skull is a complex structure formed by the craniofacial bones’ elaborate organization. The growth pattern in each craniofacial bone of the postnatal skull has been presented in wild-type mice. However, the skull’s growth pattern, determined by the craniofacial bones’ coordinated growth, is unfamiliar. This study aimed to examine the overall morphological change in the mid-sagittal plane of the postnatal mice’s skulls and interaction between the craniofacial bones.
Methods
Geometric morphometric principal component analysis was performed in the mid-sagittal plane of 31 wild-type mice’s skulls from postnatal days 28 to 98. The relationship between the cranial base and cranial vault was investigated by comparing skulls with early fusion and non-fusion of intersphenoid synchondrosis (ISS).
Results
The cranial vault flattening and sphenoid bone length increased with age. The cranial vault curvature and sphenoid base length showed a positive correlation that was confirmed by comparing the skulls with early fusion and non-fusion of ISS. The sphenoid bone length and cranial vault angle significantly decreased in the skulls with early fusion of ISS compared to non-fusion skulls.
Conclusions
It is suggested that the cranial vault flattening is sphenoid bone length-induced but cranial vault length-independent during postnatal mice skull development.
INTRODUCTION
The craniofacial skeleton is formed by 2 mechanisms of bone formation; intramembranous bone formation and endochondral bone formation.[1] The cranial base is formed via endochondral bone formation in a manner similar to long bones in the body, while facial bones and cranial vault bones are formed by intramembranous bone formation.
The cranial base contains multiple growth centers called synchondroses, which are made up of mirror-image growth plates.[2,3] Two synchondroses in the anteroposterior mid-sagittal plane of the cranial base; the pre-sphenoid and basisphenoid bones are joined by intersphenoid synchondrosis (ISS), and the spheno-occipital synchondrosis (SOS) joins the basisphenoid and occipital bones. ISS and SOS contribute significantly to the growth of the cranial vault and upper face as well as the skull base.[2,4] The cranial vault consists of frontal bones, parietal bones, the squamous parts of the temporal bone, and the interparietal part of occipital bone.
The skull is a complex structure formed by the elaborate organization of many bones. Therefore, it was not easy to fully understand the growth of the craniofacial bone. Accurate analysis of craniofacial structures in various mouse models largely depends on an in-depth understanding of the normal craniofacial development of mice. Two recent studies have well-documented the 3-dimensional (3D) metrics of the normal craniofacial development in postnatal skulls in male and female C57BL/6 mice which is one of the most commonly used inbred mouse strains.[2,5,6] It has been suggested that female C57BL/6N mice have generally a very similar craniofacial growth pattern to male C57BL/6J mice.[3] These 2 previous studies presented a reference standard for craniofacial growth of mice up to nearly 4 months of age through a new attempt to place landmarks on the 3D reconstructed skulls using micro-computed tomography (CT) and measure the distance and angle between these landmarks. However, changes in the overall profile of the skull, which are harmoniously created by changes in length and angle, were not presented.
In this study, we performed geometric morphometric analysis of postnatal growth pattern in the mid-sagittal skulls of C57BL/6N mice from postnatal day (P) 28 to P98, and found 2 distinct geometric morphometric changes in the angle of the cranial vault and the length of sphenoid bone. We also found a close relationship between the cranial vault and the sphenoid bone, and tried to verify the relationship.
METHODS
1. Animals
All animal experiments were performed under approved protocols of the Intramural Animal Use and Care Committee of the College of Dentistry, Yonsei University. C57BL/6N mice were euthanized utilizing CO2 exposure at selected postnatal ages (P28 mice N=6, P42 mice N=4, P63 mice N=4, P70 mice N=4, P98 non-fusion mice N=8, P98 early fusion mice N=5). The number of mice per stage was determined based on previous C57BL/6 mouse studies, all of which used 4 mice per stage.[3,5] We used a minimum of 4 mice per stage in the present study.
2. Micro-CT and reconstruction
Micro-CT images of the fixed mouse skulls were obtained using a micro-CT scanner (Skyscan1173; Bruker-CT, Kontich, Belgium) at 130 kV and 60 μA and were reconstructed using NRecon (Version 1.6; Bruker-CT) with consistent parameters (Fig. 1A).
The reconstructions were converted to 3D volumes using the software 3D Slicer (Version 4.1; http://www.slicer.org; Harvard Medical School, Boston, MA, USA). Linear measurements and angular measurements were measured using the micro-CT files by using Blender and OnDemand3DTM (Version 1.0; CyberMed Inc., Daejeon, Korea).
3. Landmark-based geometric morphometric analysis
The 14 landmarks (Fig. 1B and Table 1) were positioned in the mid-sagittal plane of the 3D skulls using the software Blender (Version 3.2.1; Blender Foundation, Amsterdam, the Netherlands), and the values of the 3D coordinates were exported. All of these landmarks were described previously.[5–8] Principal component (PC) analysis is a widely used multivariate analysis method based on geometric morphometric data to reveal systematic covariations among a group of variables after removing size factor between samples. We conducted PC analysis on procrustes shape coordinates for mid-sagittal skulls using the software MorphoJ (Klingenberg Lab, Manchester, UK).
2. Statistics
The correlations were calculated as the coefficient of determination (R2) value by Excel (Microsoft Corp., Redmond, WA, USA). The difference in bone length between groups in each parameter was tested statistically with Mann–Whitney U test using SPSS (version 26.0; IBM Corp., Armonk, NY, USA). All P-values of less than 0.05 were considered significant.
RESULTS
1. The cranial vault angle is closely related with the sphenoid bone length
To investigate the postnatal growth pattern in the mid-sagittal skulls of C57BL/6N mice, a 3D geometric morphometric analysis was performed in skulls at P28, P42, P63, P70, and P98 (Fig. 2A). PC analysis shows that skulls from the same group were well clustered. The youngest skulls were located on the left, and the older skulls showed a higher PC1 value on a PC plot. Skulls of older mice scoring a positive value for PC1 exhibited the flatter cranial vault and the longer sphenoid bone length. PC1 was positively correlated with the centroid size of skulls (R2=70.68%, P< 0.0001). There were no significant changes in the length of the cranial vault bones and occipital bone in the PC analysis. In the facial region, the position of the nasal bone tip changed, but there was no significant change in the curvature or length of overall facial bones. Based on the finding that the cranial vault flattening and the sphenoid bone length increased with age, we focused on the cranial vault and skull base in this study.
Furthermore, we investigated the correlation between the curvature of the cranial vault and the length of sphenoid bone. To quantify the curvature of the cranial vault, we measured and summed the angles at bregma and lambda, the 2 points with the most prominent positional change in PC analysis. We found that the cranial vault curvature and sphenoid base length had a positive correlation (R2=0.7662) (Fig. 2B). On the other hand, there is no direct relationship between the cranial vault angle and cranial vault bone length (R2=0.4887) (Fig. 2C). These results indicate that the curvature of the cranial vault was positively correlated with the length of the sphenoid bone, but not with the length of the cranial vault.
2. The cranial vault is domed in mouse skulls with early fusion in the ISS
To confirm the positive correlation between cranial vault curvature and sphenoid base length, a 3D geometric morphometric PC analysis was performed in the mid-sagittal skulls showing early fusion of ISS. Five skulls showing early fusion of ISS were obtained at P98 mice, but we could not find skulls with early fusion of SOS at P98 mice. The skulls with the early fusion of ISS show a domed cranial vault compared to non-fusion skulls (Fig. 3A, B), a complete fusion between presphenoid and basisphenoid bone (Fig. 3C, E).
In PC analysis, the early fusion skulls were clustered on the left along the PC1 value on a PC plot, and the non-fusion skulls were clustered on the right (Fig. 4A). The early fusion skulls with negative scores of PC1 showed domed cranial vault and a shorter sphenoid bone length. PC1 is positively correlated with the centroid size for all the skulls (R2=92.33%, P<0.0001). There were no significant changes in the length of the cranial vault bones, occipital bone and facial bones in the PC analysis. This result means that the cranial vault curvature and the sphenoid bone length are closely related and that sphenoid bone length and the cranial vault angle were significantly decreased in the ISS early fusion skulls compared to non-fusion skulls (Fig. 4B, C).
DISCUSSION
To investigate the postnatal growth pattern in the midline of C57BL/6 mouse skulls, the geometric morphometric analysis was performed in the mid-sagittal skulls at P28, P42, P63, P70, and P98. We excluded skulls between p7 and P21, which have been reported to show a rapid change in all dimensions of the skull.[3,5]
1. Relationship between cranial vault angle and sphenoid bone length
We found that the cranial vault flatness and the sphenoid bone length in the mid-sagittal skulls increased with age and that the cranial vault curvature was positively correlated with the sphenoid bone length but not with the cranial vault length. These results are consistent with the result of previous reports.[2,3,5,6] The mid-sagittal angles in cranial vault continuously increase until P90 [2] and the cranial base growth in the anteroposterior dimension completely stops after P120.[3,5,6] There is no significant length change in the bones of the cranial vault between P60 and P120.[3] Furthermore, it has been suggested in previous studies that the ISS and SOS in the cranial base contribute significantly to the growth of the cranial vault.[2,4] Similar to this, in the present study, it is suggested that the sphenoid bone contributes to the cranial vault curvature.
2. Contribution of the ISS in cranial vault curvature
To confirm the correlation between cranial vault curvature and sphenoid base length, we compared skulls with early fusion and non-fusion of ISS. The fusion time of ISS and SOS was reported in previous studies. The ISS completely fused sometime after P120 [5] or after P180,[3] and the SOS completely disappeared at P390.[3] In this study, we could obtain 5 wild-type skulls with early fusion of the ISS at P98. A geometric morphometric PC analysis in the present study showed the shorter sphenoid bone length and the more curved cranial vault in the ISS early fusion skulls compared to non-fusion skulls. In many mouse mutants with premature fusion of ISS or SOS, such as Col2a1-Cre;Fgfr2IIIc P253R, Fgfr2IIIc −/−, Fgfr2c C342Y/+, Fgfr3 P244R+/−, Fgfr3G369C/G369C, Dermo1-Cre;Pkd −/−, Wnt1-Cre;Pkd2 −/−, Col2α1-Cre;IFT8−/−, Dermo-Cre;POR −/−, Alpl −/−, and BALB/c-bm/bm mice, domed cranial vaults were accompanied.[9–20] Especially, Col2a1-Cre; Fgfr2IIIcP253R and Col2α1-Cre;IFT8−/− mice, whose mutations are controlled by a cartilage-specific promoter in the cranial base, exhibited a premature fusion of ISS or SOS and a domed cranial vault together.[9,17] Based on results of wild-type mice in the present study and mutant mice in previous studies, it is suggested that the cranial vault flattening is driven by the sphenoid bone lengthening, but is independent of the cranial vault length during postnatal mouse skull development.
The data from C57BL/6 mice in the present study are unlikely to be directly applicable to humans because there are striking morphological differences between human and mouse skull bases. First, the overall shape of the sphenoid bone is completely different between humans and mice. In the lateral view, the body of the sphenoid bone is curved in humans and the sphenoid bone in mice is flat. Due to these differences, the angle at the base of the skull is highly flexed at an acute angle in humans. On the other hand, the skull base angle is retroflexed (>180° when measured ventrally) in mice, just as it is flat or obtuse in most mammals.[21] Second, the postnatal cranial base angle decreases in mice,[3,5] but increases in humans.[21] It has been suggested that cranial base flexion contributes more than the cranial base length to allow a larger cranial volume in humans.[22] Furthermore, it is very difficult to fully establish the developmental pattern of the human skull due to environmental factors and high genetic heterogeneity.[23] In this respect, skull studies in highly inbred mouse strains are meaningful in that they can provide a clue to understanding mammalian skull development patterns based on genetic diversity and minimization of environmental factors within the strain. Similar to this, further studies are needed to determine whether the data from C57BL/6 mice in the present study apply equally to other mouse strains, since a previous study examining the skull morphology of C57BL/6, BALB/cA, C3H/HeJ, CBA/JNCr, ICR, MSM/Ms, and Mus spretus indicated that the skull morphology was highly variable between mouse strains and clearly geometrically distinguishable.[24]
Notes
Funding
This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT). (No.2020R1A2C2005790).
Ethics approval and consent to participate
All animals were treated in accordance with the Guide for the Intramural Animal Use and Care Committee of the College of Dentistry, Yonsei University.
Conflict of interest
No potential conflict of interest relevant to this article was reported.